Installing The Belt Clip; Installing The Cap Over The Universal Connector - Kenwood Nexedge serie Bedienungsanleitung

INSTALLING THE BELT CLIP

Attach the belt clip using the
supplied M3 x 10 mm screws.
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
transmission or when left sitting in
a hot environment.
Do not use glue which is designed to prevent screw loosening when
installing the belt clip. Acrylic ester, which is contained in these
glues, may crack the transceiver's back panel.

INSTALLING THE CAP OVER THE UNIVERSAL CONNECTOR

Insert the cap into place over the
universal connector and secure it
in place using the attached screw.
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE
1 Insert the guide of the speaker/ microphone connector
into place over the universal
connector.
2 Secure the connector in place
using the attached screw.
Note: When not using an optional
speaker/ microphone, install the
cap over the universal connector.
Belt clip
Screws
Universal
connector cap
Speaker/ microphone
3