Installing The Belt Clip; Installing The Optional Speaker/ Microphone (Or Headset) - Kenwood TK-3601D Benutzerhandbuch

INSTALLING THE BELT CLIP

INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR
HEADSET)
1 Turn the transceiver power OFF.
• For transceivers that are able to adjust the volume level, adjust the volume
to the minimum setting before turning the transceiver power OFF.
2 Insert the plug into the SP/MIC jack on the transceiver, then fi x it
with a nut.
• Fix the plug with a nut fi rmly to maintain waterproof protection for the
transceiver.
• The transceiver is not fully water protection when using a speaker/
microphone or headset.
• When not using an optional speaker/ microphone, clip mic. with earphone,
or headset, to keep the transceiver dust and water protection, you must
cover the SP/MIC jack with the cap securely with no gap.
Plug
SP/MIC jack cover
If necessary, attach the belt clip using
the two supplied M3 x 8 mm screws.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
Nut
11