Use And Operation - Chal-Tec 10002073 Bedienungsanleitung

Checking the Fuse
1. The unit comes standard with pre-installed
fuse. Remove the protective cover labeled
'Fuse' with screwing movements.
Ladegerät und Ladestatus
1. Connect the charger with the 1-pin socket
on the electric scooter. Connect the power
plug of the charger to a wall outlet.
Handlebar controls
Before your first ride, familiarise yourself with the handlebar controls of the scooter while it is in the
'0' state. Once you are secure, switch the on / off switch to the ‚1' position.
Downloaded from www.Manualslib.com

Use and Operation

manuals search engine
2. If a fuse is found in place, keep it in its posi-
tion and screw the protective cover back on.
If no fuse is found in place, take one of the
supplied spare fuses and install it according
to the instructions contained in the 'Fuse'
section of this manual.
2. If the unit is uncharged or insufficiently
charged, the status LED will glow red and
green. In a fully charged state, only the red
LED will glow.
The scooter has an adjustable accelera-
tor throttle grip.
Turn the right handle slowly towards
yourself to add gas. As you turn the
handle further, the engine retrieves
more power and the speed increases.
When you release the throttle grip, the
handle returns to its original position
and the engine will stop retrieving po-
wer, thus gradually slowing the device.
13