Checking The Fuse And Charging - Chal-Tec 10002073 Bedienungsanleitung

Saddle mounting (optional)
1. Insert the lower seat post into the latching
connectors. Bolt the clamp securely.
3. Place the saddle on the seat post and fas-
ten it securely using the side-lying screws.
Important Hints on Battery and Adaptor
• Ensure that the power supply voltage corresponds to the value indicated on the power supply.
• The power supply can be operated with an alternating current of 220 - 240 V.
• Use an appropriate plug adapter if the plug does not fit into your socket.
• Insert the power cord fully into the outlet.
• Do not pull on the cable. Do not bend the cable or place heavy objects on top of it.
• Do not handle the plug with wet hands.
• Hold the plug when pulling it out of the device.
• Do not use a damaged mains plug or a damaged socket.
• Install this unit so that the power cord may be disconnected from the mains socket if a problem
occurs.
Attention
• You must fully charge the battery before first use.
• Charge immediately after each use of the scooter.
• Charge batteries before storing. You must charge the battery every 30 days if the scooter is not
in use.
• Make sure that the batteries never fully run out.
• For safety reasons, do NOT charge for over 24 hours.
• Switch the unit OFF when not in use.
• NEVER leave or store batteries near fire or heat.
Downloaded from www.Manualslib.com
Ckecking the Fuses and Charging
manuals search engine
2. Adjust the height of the saddle bar by loo-
sening the top clamp on the inner rod of the
saddle bar until the saddle is at a suitable
height and then retighten the clamp.
4. Check that the saddle is securely fastened
with strong upward, downward and side-
ways movements. The saddle should be se-
cure while still allowing for room to move.
12