Wiring Diagrams; Mounting Instructions - IME Conto D4-Pd Installationsanweisungen

Wiring Diagrams

The meter can be used with single-phase or 3-phase line with common
ground; please scrupulously respect the wiring diagram. The input
configuration must be completed with the keyboard programming of the
chosen connection type as well as of any external CT or VT ratios.
For a proper working of the meter, the phase connected with terminal
1 must always be present.
S 1000/364
L(a)= L1 or L2 or L3
I N P U T
L(b)= L1 or L2 or L3
L(c)= L1 or L2 or L3
1 3 4 6 7 9
L (a)
L
(b)
L (c)
N
03/16 10783362 WEB E cod.CE4DT36
O U T P U T
RS 485
Rx / Tx GND
+ –
A C
11 B
LOAD
Conto D4-Pd

Mounting Instructions

Mounting of this equipment must be carried out just by skil
led personnel.
Please make sure that the data on the label
correspond to the network on
measuring current, frequency)
which the meter must be connected.
In the wiring scrupulously respect the wiring diagram; an
error in connection unavoidably leads to wrong measure-
ments or damages to the meter.
When the meter is connected, conclude the mounting with
the configuration as described in the user's manual.
(measuring voltage,
3