Conel CLEAR Serie Montage- Und Betriebsanleitung Seite 25

LAN cable to the
home router
After connection of the LAN cable and the device connection cables, the power supply unit of the CLEAR
water treatment device is plugged in. If multiple devices are connected, their power supply units are also
plugged in.
The CLEAR BOX then starts up and automatically makes a connection to the home router.
The connection status is indicated by the LEDs of the CLEAR BOX (see fig. 2).
Green LED
On: connected to the internet
Off: no internet connection
Amber LED
Flashing: connecting to the devices.
On: devices successfully connected.
Off: fault, it is not possible to connect to the device.
Red LED
This LED does not currently have any function.
CLEAR BOX reset button
Firmware reset: press button for 5 s.
Restart manual configuration identification of the connected devices: Press button briefly.
1 2
Connection cables to the CLEAR water treatment
devices (LAN cable with RJ-45 plug)
Fig. 1: Connection area (view from below)
Fig. 2: LEDs and reset button of the CLEAR BOX
3 4
Red LED
Green LED
Amber LED
Reset
button
25