Emmaljunga First Class 0+Base Adapter Go Double Gebrauchsanweisung Seite 21

Usage of the Adapter
1
2
1
2
4
3
3
4
9
5
10
10
Manual First Class 0+Base Adapter Go Double v. 1.1
Attaching the First Class0+Base Adaptor to the chassis
Attach the Go Double Adaptor to the chassis according to it´s manual.
• Engage the brake.
• Attach the First Class0+Base Adaptor on to the Go Double by push-
ing the attachments points on the Adaptor into the receivers of the
chassis' Easy Fix locking mechanism (1) until you hear it click into
place.
• The Adaptor should be positioned so that the two curved tubes (2) of
the Adaptor point towards the handle of the pram.
WARNING
• Always engage the brake when you attach the First Class0+Base
Adaptor to the Go Double.
• Make sure that the Adaptor is securely attached to both receivers of
the Easy Fix locking mechanism on the Go Double.
• Never lift the First Class0+Base Adaptor when it is attached to the
Go Double.
Attaching the Emmaljunga First Class0+Base car seat to the
Adaptor
• Hold the Emmaljunga First Class0+Base car seat by the handle
and attach it to the Adaptor (3) so that the foot end of the car seat
is pointing towards the handle of the pram (4).
• Click the Emmaljunga First Class0+Base car seat on to the Adaptor
by pressing it down on to the Adaptor until it clicks into place. Make
sure that the car seat clicks into place securely on the adaptor's
four attachment points.
• Hold the Emmaljunga First Class0+Base car seat at all times by the
carrying handle and do not release your hold until you have secure-
ly attached the car seat to the Adaptor.
• The Emmaljunga First Class0+Base is now correctly assembled on
the Adaptor and the chassis.
Removing the car seat from the Adaptor
• Engage the brake of the pram
• Release the car seat by first adjusting the handle from its position
at the head end of the car seat, into an upright position. Whilst hold-
ing the carrying handle with one hand, activate the release mecha-
nism at the rear of the car seat with the other hand (8) and then lift
the car seat straight up (9).
8
WARNING
• Always engage the brake before releasing the car seat.
Removing the First Class0+Base Adaptor from the chassis
• Release the Adaptor from the chassis by pulling the plastic rings
(10), which are positioned on the Easy Fix attachment points of the
First Class0+Base Adaptor.
• Lift the Adaptor straight up from the chassis.
IMPORTANT
• Before you fold the chassis in accordance with the instructions in
the pram manual, you must remove the car seat.
WARNING
• Never release the Adaptor from the chassis when the car seat is
attached to it.
21