Secura QLF110 Montageanleitung Seite 8

2
Mount to Wall
Wood Stud
2-1
Locate stud
< 16 mm
(5/8 in.)
2-2
Level wall plate [01] and mark hole locations
[01]
2-3
Drill pilot holes as illustrated
2-4
Tighten lag bolts [05]
[01]
8
[06]
[05]
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 50.8 x 101.6 mm (2 x 4 in. )
(nominal 38.1 x 88.9 mm (1½ x 3½ in.)).
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage: pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7⁄32 in.) diameter drill bit.
75 mm
(3 in.)
Tighten lag bolts [05] only until the washers [06] are pulled fi rmly
against the wall plate [01].
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage: DO NOT
over-tighten the lag bolts [05].
13 mm
5.5 mm
(1/2 in.)
(7/32 in.)
6910-002041 <00>