Attaching To Camera; Power Management - Hahnel Modus 600RT Bedienungsanleitung

Battery Level
Indication
3 bars
2 bars
1 bar
No bars
Blinking

Attaching to Camera

Power Management

Use ON/OFF Power Switch to power the flash unit on or off. Turn off if
it will not be used for an extended period of time. Setting as a master
flash, it will turn the power off automatically after a certain period
(approx. 90 seconds) of idle use. Pressing the camera shutter halfway
or pressing any flash button will wake up the flash unit. Setting as a
slave flash, it will enter sleep mode after a certain period (adjustable,
60 minutes by default) of idle use. Pressing any flash button will wake
it up.
Disabling Auto Power Off function is recommended when the flash
is used off camera. (C.Fn-APO)
Slave Auto Power Off Timer is set to 60 minutes by default. Another
option "30 minutes" is available. (C.Fn-Sv APOT, Page 38)
Modus 600RT
Meaning
Full
Middle
Low
Lower battery, please recharge it
The battery level is going to be used out
immediately.
Note: Please recharge the battery as soon
as possible (within 10 days). Then, the
battery can be used or stored as detailed in
the "How to store the battery" section.
1. Attach the Speedlight
2. Secure the Speedlight
3. Detach the Speedlight
to the camera.
Slip the flash's mounting foot
into the camera's hotshoe all
the way.
Rotate the lock ring on the
mounting foot until it locks
in position
Rotate the lock ring on
the mounting foot until it is
loosened. Then slide the
speedlight off the camera
hotshoe
15