SEVERIN KB 2921 Gebrauchsanweisung Seite 8

●
This appliance is only intended for
domestic use and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel. If repairs are
needed, please send the appliance to one
of our customer service departments.
The address can be found in the
appendix to this manual.
General information
This cool-box uses thermo-electric
technology and is therefore able to provide
cooling as well as heating. The appliance
cools down to as much as approx. 20° C
below ambient temperature.
Operation mode selector switch
The cooling function is switched on.
0 The appliance is switched off.
The appliance is in keep-warm mode.
Voltage selector switch
The voltage selector switch setting must
correspond to the power source currently
being used. Always ensure that the switch is
in the correct position before the cool-box is
connected to any power source.
AC power – for 230V mains operation,
the voltage selector must be set to AC
voltage.
DC power – for operation from a 12V
power source, the voltage selector must
be set to DC voltage.
Indicator lights
The 'cooling' function is indicated by the
green light.
The red indicator light shows that the 'keep-
warm' function is enabled.
Lid
The lid can be locked by folding the carrying
handle over towards the hinged side of the
lid. To unlock, move the handle to the
Downloaded from www.Manualslib.com manuals search engine
opposite side.
Operation
- Place the lid on the cool-box, ensuring
that the hinges on the lid connect
properly with the receptacles on the cool-
box itself.
- Use the voltage selector switch to set the
required voltage.
- Insert either the 12V connector plug or
the mains power plug into the
appropriate socket on the cool-box.
- Connect the 12V cigarette-lighter plug
into a suitable 12V socket, or insert the
mains plug into a suitable mains outlet.
- Set the selector switch to either the
cooling or the warming function. The
appropriate indicator light will come on.
- To compartmentalise the cool-box, the
partition may be inserted from above
into the 2 grooves on the inside.
- During periods of non-use, always switch
off the cool-box and disconnect the cable
last used from the power source.
Remarks
Cooling
To achieve optimum cooling, the cool-box
should be filled with pre-chilled food and/or
beverages. The food and beverages will then
be kept cool or be cooled down even further.
With warm or non-chilled food and
beverages, the cooling process will take
considerably longer.
Keeping warm
Using the keep-warm function, food and
beverages may be kept warm. Again,
warming up cold food and beverages will
take some considerable time.
12V connection:
When the 12V cigarette lighter socket is
used to power the cool-box, it should not be
left connected for more than 2 hours with
the vehicle engine switched off. This is to
prevent the vehicle battery from over-
8