Inhaltsverzeichnis
Werbung
SPECIFICATIONS
• 4-family panel
• Surface-mounted
• Vandal-resistant zinc alloy housing
• Resolution: 800 TVL
• Signal type: CVBS
• LED illumination
• NO/NC strike control
DESCRIPTION
FRONT
INSTALLATION
1. Follow the wiring connection diagram and verify that all wiring connections are correct.
2. Choose the right place to install the entrance panel in. An installation height between 1.5
and 1.6 m above the ground is recommended.
3. The entrance panel video camera should be away from direct sunlight and deep
shadows.
4. Verify that the power supply voltage is OFF before wiring the device.
5. Power on the supply voltage of the device when completely installed.
6. Seal the back plate edges of the entrance panel all along at the installation surface with
a waterproof silicone product during the installation. This will prevent condensation of
humidity between the entrance panel and its installation surface in certain weather
conditions. Condensation of humidity on the surfaces is a risk of corrosion of electronic
components in the device and mechanical stress from freezing of condensation at low
temperatures.
• Dust and water proof: IP66
• Operating temperature: -30°C to +60°C
• Dimensions: 154x55x18mm
• 110° wide-angle camera
• Video output: 1 Vp-p75Ω
• Supply voltage: 10-15V DC
• Input power: 2.5 W
1. Microphone
2. Camera
3. LED illumination
4. Call button
5. Label displays
6. Speaker
7. Harness 2
8. Harness 1
BACK
Werbung
Inhaltsverzeichnis
