Function Buttons - Honeywell TC09PCE Benutzerhandbuch

USE & OPERATION (CONTINUED)

FUNCTION BUTTONS

POWER
Press the button to turn the unit on. The cooler will start automatically at medium speed. After a
few seconds the speed will switch to low. To turn the unit off, press the button again.
MODE (COOL / IONIZER*^)
You must add water before operating the unit. Press the MODE button to select COOL and IONIZER
modes.
Pressing the MODE button until COOL
cooling. The water pump will operate and you will feel the cooler air after the Honeycomb Cooling
Media is completely wet.
Pressing the MODE button until IONIZER
reduce particles in the air, thus promoting cleaner air quality.
Pressing the MODE button until both COOL
evaporative cooling and Ionizer together.
Pressing the MODE button again will deactivate both COOL
panel, switching off both evaporative cooling and Ionizer function altogether.
SPEED
Press the SPEED button repeatedly to change the speed between | - || - |||.
SWING
Press the SWING button until
begin to move left to right automatically. You can manually adjust the louvers
to change vertical air flow.
is illuminated on the control panel activates evaporative
is illuminated activates Ionizer. An Ionizer helps to
and IONIZER
is illuminated on the display. The louvers will
^ Ionizer reduces particles in the air. This is not an air purifier.
EN
are illuminated activates both
and IONIZER lights on the control
* Applicable for models with Ionizer feature only.
Louver
Movement