PCL NEXUS serie Bedienungsanleitung Seite 3

1. Install filter-regulator (ATC12).
Remove filter-regulator unit and dial gauge from packaging and
apply PTFE tape to the dial thread before screwing into the unit.
Fig 1
2. Installation of filter-regulator mounting brackets
Locate holes on side of cabinet and mount the brackets to these
using the screws and washers provided (fig2). The two slotted
bracket mounts are already pre-attached to the filter (fig3).
Fig 2
Re-apply PTFE tape
Dial
Fig 3
Front
www.pclairtechnology.com
NEXUS Generator & Inflator user manual
3. Attachment of pneumatic pipe to the filtration unit.
Pipe A is attached to the right hand side of the filter-regulator via a
push in fitting.
Fig 4
4. Installation of hose mounting hooks
There are two mounting hooks (Fig 5) that need mounting on each
side of the cabinet. Screws and washers are provided. Simply
locate mounting holes on the side of cabinet and install (Fig 6)
Fig 5
B
A
Grommet
N6 Version
Fig 6