Honeywell CL25AE Serie Benutzerhandbuch Seite 8

USE & OPERATION (CONTINUED)
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
• The appliance is supplied with a Carbon Dust Filter* & Honeycomb Cooling Media.
• The Carbon Dust Filter* and Honeycomb Cooling Media are located inside the Rear Grill. See
Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.
• Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
•
The cleaning frequency for the Honeycomb media depends on local air and water conditions.
In areas where the mineral content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh
water at least once a week will help reduce mineral deposits. If mineral deposits remain on the
Honeycomb Cooling Media, the media should be removed and washed under fresh water. The
media should be cleaned every two months or sooner, depending on your needs.
•
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
1. Remove all the screws from the Rear Grill.
2. Carefully push the left and right side of the rear
grill and pull out from the cooler.
3. Pull out the Carbon Dust Filter* and clean with
water as needed.
4. To release the Honeycomb Media pull out the
Rear Frame and slide the Honeycomb out of the
frame.
5. Replace or clean media with water and a damp
cloth as needed.
WARNING: DO NOT operate the Air Cooler when the
Rear Grill or Rear Frame is removed from the Air
Cooler, or if there is a loose-fitting Rear Grill or
Rear Frame. Doing so can cause serious injury or
dangerous electrical shock.
Figure 1:
*Applicable for models with Carbon Dust Filter only.
EN 7
Honeycomb
Cooling Media
Rear Frame
Carbon Dust
Filter
Rear Grill
Push
Push
Screws