Filling With Water - Honeywell CL25AE Serie Benutzerhandbuch

USE & OPERATION (CONTINUED)
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please
refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.

FILLING WITH WATER

CAUTION:
Unplug the unit from the electrical power outlet before emptying
or refilling the water tank.
Open the Water Fill Door located on the side of the unit.
The Water Level Indicator is located at the front of the unit.
Refill the water tank when water level is low. Do not fill water above
the "Max." water level mark to avoid water droplets collecting on
the louvers. Check the water level in the tank before running the
COOL function. Make sure that the water in the tank is above the
minimum water level mark. Running the unit in COOL mode with
inadequate water may cause pump failure.
Note: The water capacity refers to the total volume of water
that can be contained within the air cooler water tank and water
distribution system. The water capacity in the tank at the "Max."
indicator level may be lower than the actual water capacity of the
air cooler.
Note: If ice is available, you may add ice in the top ice compartment
to enhance the cooling performance.
WARNING: Do not fill water tank with dirty water or salt water. This
can damage the unit and Honeycomb media.
EN 5
Water
Fill Door
Ice Compartment