Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Did you wait a few moments when changing the connection
from the computer used for setup to the other device?
After disconnecting the cable from the computer used for setup, do not plug
it immediately into the new device. Wait at least 10 seconds before plugging
it.
The device information accumulated on the computer takes about 10 seconds to be
added.
Case 11 - I forgot settings or want to reset
Proceed as follows:
1
When the Wireless LAN Converter is on, use a paper clip or a similar object
to hold down the reset switch located (1) on the bottom of the Wireless
LAN Converter.
2
Release the switch when the STATUS indicator starts to flash red.
The Wireless LAN Converter restarts automatically and all settings revert
to the factory defaults. Configure the Wireless LAN Converter again as
needed.
Be careful not to press the Quick Setup switch when you reset the Wireless LAN
Converter. Pressing the Quick Setup switch (2) does not reset the Wireless LAN Converter.
10
Downloaded from
www.Manualslib.com
manuals search engine
Werbung
