Figure 1-2. Removing A Microprocessor Assembly Or Terminator Card - Dell PowerEdge 8450 Aufrüstungshandbuch

support.dell.com
Downloaded from www.Manualslib.com
retention screws (2)
Figure 1-2. Removing a Microprocessor Assembly or
Terminator Card
c. Slide the microprocessor assembly or terminator card up and out of the
microprocessor cage and place it on an antistatic mat.
d. Repeat steps a through c to remove the remaining microprocessors or
terminator cards.
manuals search engine
retaining clip
latches (2)
microprocessor assembly
Microprocessor Board Upgrade Guide 1-5