Cleaning Plasma Filter; After Cleaning - Fakir VITA Benutzerhandbuch

EN

Cleaning plasma filter

• Use a mild detergent to clean plasma filter.
• You can use a soft cloth or a toothbrush to clean the filter.
• For a better result, use warn water not exceeding 40 degrees.
1
2
1. Plasma Filter
2. Electric Current Wires
• If it is heavy dirty, place the filter in detergent added water and then clean using a toothbrush.
- When cleaning dust filter, take care not to damage the wires on it. If a wire is damaged, dust
collection of the appliance can be degraded partly or completely.
- If a wire is broken,do not let it inside the appliance and remove it completely. Otherwise,
there is a risk of short circuit of the appliance.
- If wires get damaged, contact Fakir Authorized Service.
- Never use alkali or acid based detergents which may cause rusting on the appliance.

After Cleaning

• Before installing the filters, make sure they are completely dry. Otherwise, there is a risk of
electric shock or the appliance can get damaged.
• If front cover is not installed properly, the appliance will not operate.
• After cleaning, check that plastic covers preventing contact of wires to the surface are
properly located.
28