SanDisk Connect ComapctFlash Bedienungsanleitung Seite 54

MAC Layer Link Test
The MAC Layer link test is used to check the quality of transmission between
your computer and an access point. In Infrastructure mode, you don't need to
enter a remote address.
The results of the MAC Layer link test appear on the right side of
the dialog box.
Page 50
Downloaded from www.Manualslib.com
Percent is the percentage of failed packets.
1. If the network type is Ad-hoc mode, enter the MAC address in the
Remote Address field.
2. Enter a Test Interval (a time limit for the test). The Test Interval is shown
in milliseconds.
Enter a Packet Size.
3.
Click Loop Back.
4.
Click the Refresh button to set the counters to zero.
5.
To stop the loop back test, click Loop Back again.
6.
Packet Count is the number of packets sent.
Failure Count is the number of failed packets.
Percent is the percentage of failed packets.
manuals search engine