Texi Fox 25 Benutzerhandbuch Seite 87

Machine does not feed at all
Machine does not feed
properly
Machine doesn't work
Machine works too laud or
too slow
LED lamp doesn't work
SAVE THESE INSTRUCTIONS
This product is for household use, or equivalent. This appliance complies with EMC Directive 2014/30/
EU covering the electromagnetic compatibility. Please note that on disposal, this product must be safely
recycled in accordance with relevant National legislation relating to electrical/ electronic products. If in
doubt please contact your retailer for guidance.
Lint or dust accumulated around feed
dog
Feed dog lever are lowered
Stitch length is too small
Stitch length is with value 0
Bobbin thread is about to end
Machines is not plugged
Main switch is in position „0"
Buttonhole lever is lowered
Buttonhole is raised during
buttonhole sewing
The thread tangled up in bobbin
Dirt in the bobbin and hook area
blocked feed dog
Machine has no oil
Main switch is in position „0"
Lamp got burnt
Texi Fox 25
Clean feed dog area
Check if feed dog lever is on right
position
Adjust stitch length
Adjust stitch length
Rewind thread on the bobbin
Insert plug fully into outlet
Turn on the switch to „1"
Raise buttonhole lever
Lower buttonhole lever
Reinsert bobbin and thread
Clean feed dog
Oil the machine
Turn on the switch to „1"
Replace LED lamp for new one
EN
87