Yukon Photon RT Betriebsanleitung Seite 16

Problem Check
There are several Presence of dots is caused
light or black dots by peculiarities of sensor or
(pixels) on unit's display production
display. technology
and is not a defect.
25
Corrective action
4) Release the REC button and the controller. The original
firmware is being installed which may take up to 1 min.
After successful firmware installation display will steadily glow.
5) Disconnect the riflescope from the power supply (remove
the batteries or disconnect an external power supply).
The riflescope will not turn off with the ON button.
6) The riflescope is ready to operate.
This is not a defect.
NOTES
26