Yukon Photon RT Betriebsanleitung Seite 15

Problem Check
Check that the batteries are correctly fitted in
The unit will not turn on.
the battery compartment.
Check battery operation.
Oxidized contacts in the battery compartment
due to "leaky" batteries or contacts have been
exposed to a chemically active liquid.
The image is too dark. The lowest brightness level is set.
Make sure the lenses are not misted or soiled.
Poor image quality. Check that the eyepiece and lens are adjusted
in accordance with the user manual.
The unit does not Make sure your power supply Is providing
output voltage.
operate on external
power supply.
With a crisp image of the Dust and condensate are covering the outside
reticle, the image of the optical surfaces after the sight was brought in
observed target that is at from the cold into a warm environment, for
least 30 m away is blurred. example.
The objective lens is not focused.
23
Corrective action
Replace the batteries or fit the batteries
correctly.
Clean the battery compartment,
clean the contacts.
Adjust brightness by rotating the
controller.
Clean the lenses with a cloth
moistened with alcohol.
Adjust the unit according in
accordance with the user manual.
Charge the external power supply
(if required).
Check that the USB cable is intact.
Clean the lens surfaces with a blower and
soft lens cloth.
Let the sight dry by leaving it in a warm
environment for 4 hours.
Adjust the image by rotating the focusing
ring.
Problem Check
The aiming point shifts after The riflescope is not mounted
firing rounds. The riflescope securely.
will not focus.
The riflescope will not focus. Wrong settings.
The riflescope is being used in
the daytime.
No Wi-Fi signal or erratic The unit is beyond reliable Wi-Fi
signal. range.
There are obstacles between the
unit and the signal receiver
(concrete walls for example).
There are too many Wi-Fi networks
in the area where the riflescope is
located which may cause signal
interference.
Please restore the
The riflescope is not
original firmware
operating properly due to
version.
firmware update.
Corrective action
Check that the riflescope has been securely mounted,
make sure that the same type and calibre bullets are being
used as when the riflescope was initially zeroed; if your
riflescope was zeroed during the summer, and is now
being used in the winter (or the other way round), a minor
displacement of the aiming point is possible.
Set up the riflescope according to the instructions given in
the Section "Powering on and image setup" and check the
surfaces of the eyepiece and objective lenses and clean
them if necessary from dust, condensation, frost, etc; to
prevent fogging in cold weather, apply a special anti-fog
solution.
Check focusing of the scope in night conditions.
Place the unit in line-of-sight of the Wi-Fi signal.
To ensure stable Wi-Fi performance, move the riflescope
to an area with few or no Wi-Fi networks.
1) Connect an external power supply or insert batteries
into the riflescope.
2) Hold down simultaneously the REC button and the
controller.
3) Start the riflescope with a brief press of the ON button.
Display will blink two times.
24