Calling Up The Pressure Monitoring Menu; Setting The Pressure Display Unit; Setting The Minimum Pressure For Pressure Monitoring; Maintenance And Cleaning - Vieweg DC 300 Bedienungsanleitung

Operating Instructions DC 300

6.1 Calling up the pressure monitoring menu

To access the pressure monitoring menu, while the instrument is
switched on, press and hold the SET and MEM buttons .
The digital display now shows the unit for the pressure indication
("bar" or "PSI") .

6.2 Setting the pressure display unit

Use the arrow up (ñ) and arrow down (ò) keys to set the desired
unit for pressure .
Press the PURGE key to accept the value .
You can now continue to set a pressure limit .
Pressing the EXIT key the values are accepted and the device restarts .

6.3 Setting the minimum pressure for pressure monitoring

After confirming the pressure, you can set a value for the
minimum pressure with the arrow up (ñ) and arrow down (ò)
keys .
Press the EXIT key to accept the value and restart the instrument .
In order to deactivate the pressure alarm, the minimum
pressure can be set to 0 . 0

7 Maintenance and Cleaning

The dispensing controller is maintenance-free . Any needed repairs must be performed
by an authorized repair center or only by sending the unit back to VIEWEG GmbH .
To clean the unit and the housing, use only dry or damp cloths and never use cleaning
fluids such as petrol, thinners or any other flammable or corrosive liquid .
29
VIEWEG
EN
NOTICE