Balluff BOS 18MR-PA-PR20-S4 Betriebsanleitung Seite 4

BOS 18MR-PA-PR20-S4/S4S
Photoelectric Sensors – Red light retro-reflective sensor with polarizing filter
Technical Data
Optical
Functional principle retro-reflective
Sensing range with reflector
BOS R-1 6 m
Light type LED, red light
Wave length λ 620...670 nm
Polarizing filter yes
Risk group acc. to IEC 62471 Exempt group
Electrical
Supply voltage U 10...30 V DC
B
Reverse polarity protected yes
Rated operating voltage U 24 V DC
e
No-load current l < 25 mA
o
Effective operating current l 100 mA each output
e
Short circuit protected yes, both outputs
Max. capacitance for U 0.2 μF
e
Voltage drop U at l < 2.5 V
d e
Turn-on delay < 0.65 ms
Turn-off delay < 0.65 ms
Switching frequency f 800 Hz
Switching output see type list
Switching function see type list
Output function optical
BOS...-S4 light-on (Pin 2)
dark-on (Pin 4)
BOS...-S4S light-on (Pin 4)
dark-on (Pin 2)
Sensitivity setting single turn potentiometer
Utilization category DC 13
Protection class II
Rated insulation voltage 75 V DC
Mechanical
Connection type M12-connector, 4-pin
Housing material CuZn nickel plated
Active surface material glass
Tightening torque
area B1 (fig. 2) 15 Nm
area B2 (fig. 2) 30 Nm
Housing dimensions 92 mm, Ø M18x1
Weight < 50 g
Ambient
Ambient temperature T –5...+55 °C
a
Enclosure rating per IEC 60529 IP67
Ambient light rejection max. 10 kLux
english
www.balluff.com
Approvals
For use in NFPA 79 Applications only.
Proximity Switches shall be connected only by using any
R/C (CYJV2) cord, having suitable ratings.
Nur zur Verwendung in NFPA 79-Anwendungen.
Näherungsschalter dürfen nur mit einem R/C-Kabel
(CYJV2) mit geeigneten Nennwerten angeschlossen
werden.
Utilisation dans les applications NFPA 79 uniquement.
Les commutateurs de proximité ne doivent être connectés
qu'en utilisant un cordon R/C (CYJV2) de calibre
approprié.
Balluff GmbH
Schurwaldstrasse 9
73765 Neuhausen a.d.F.
Germany
Phone + 49 7158 173-0
Fax +49 7158 5010
balluff@balluff.de
english
2