Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fig.02-I:
Thermometer symbol = target temperature
Fig.02-K:
Clock symbol = time delay
Fig.02-L:
Stop symbol = device switches off
Fig.02-M:
Target temperature/ delay / cooking time in hrs. / min.
Buttons
Fig.01-D:
Red main power switch ON-OFF at the back of instrument
Fig.01-E:
°C | °F Switch at the back of the instrument
– button
Fig.02-N:
Fig.02-O:
START/STOP button
Fig.02-P:
SET button
+ button
Fig.02-Q:
Getting started
Ÿ
Clean the device outer surface with a soft damp cloth before the first use.
Ÿ
Place a cooking pot, a plastic or another suitable heat resistant container on a flat, stable and heat resistant
surface. Fasten the device support on the side of the pot or container.
Ÿ
Connect the plug to a wall socket. Important! Make sure that your household voltage is no more than 240V!
Otherwise your device may be damaged.
Ÿ
Fill the pot with lukewarm tap water. In this regard, pay attention to the Minimum and Maximum indicators on the
front of the appliance. The water level should be precisely between the two indicators.
Ÿ
Place the vacuum sealer bag containing the food into the device. Ensure that the water level does not go over the
MAX marking. Ensure that the bags are always surrounded by water.
Attention:
The water evaporates through the heating process. If the water level falls below the MIN marking, a permanent
alert will sound. The warning symbol and the stop symbol appear in the display and the heater will turn off
immediately. In this case add water and start the appliance once again.
Ÿ
Slide the red switch on the back of the instrument to the position „ON".
Ÿ
The red switch lights up.
Ÿ
All segments will be displayed briefly.
Ÿ
The icon NOW, the thermometer symbol and the current temperature appear at the top part of the display; on the
bottom part appear the icon TARGET, the thermometer symbol and the temperature (70,0°C default) flash.
Select cooking mode
Simple cooking
Press the – or + button to set the desired target temperature.
Ÿ
Ÿ
Press the START/STOP button to start the cooking process.
Ÿ
The instrument turns on and a circular symbol will appear in the middle of the display. The water begins to
circulate and to heat.
Ÿ
When the exact target temperature is reached, the target symbol appears on the display.
Cooking with time duration
Ÿ
Press the SET button. The timer symbol appears on the display.
The thermometer symbol and 70,0°C (default) flash. Press the – or + button to set the desired target
Ÿ
temperature.
Ÿ
Press the START/STOP button to confirm.
The timer symbol and 0:05 min. (default) flash. Press the – or + button to set the desired time duration for the
Ÿ
cooking process in steps of 5 minutes each.
Ÿ
Press the START/STOP button to confirm.
Ÿ
Press the START/STOP button again to start the cooking process with the desired time duration.
11
Werbung
