Lighting The Burners With An Electronic Igniter - BORETTI ADDIZIO Gebrauchsanweisung

• Note: If you are unable to close off a gas leak, then turn off the gas supply and contact
your sales outlet. Even a small leak can cause a fire.
• Note: If, after several attempts, you are unable to light the barbecue, then contact your
sales outlet.
• Note: Ensure that the control knobs are in the "OFF" position when you are not using
the equipment.
4.3 Lighting the barbecue
• Check the general conditions of the burners (see 0). If you are in doubt about the
condition of the burners, then contact your sales outlet.
• Ensure that the barbecue is placed on a level surface.
• Keep the cooking area clean and free from petrol and/or other flammable and/or
inflammable substances, flammable gasses or flammable fumes.
• Ensure that nothing is blocking the burners and ventilation.
• Do not use aluminium foil in the enamel burner tray or around the flame distributors.
• Ensure there is sufficient ventilation for the gas bottle.
WARNING:
• Do not light the barbecue if you can smell gas!
• Check the gas hose for cracks or wear and tear (see: GAS LEAK TEST).
• Keep your face and body as far away from the barbecue as possible when lighting it.

4.4 Lighting the burners with an electronic igniter

• Ensure that all knobs are in the "OFF" position.
• Always open the lid before you light the barbecue.
• Open the gas supply.
o NOTE: when opening the gas bottle, turn the valve SLOWLY two (2) whole turns to
get the right gas supply.
• Press and turn one of the control knobs to the "FIIGFI" setting. You will hear a crackling
noise. It may be necessary to keep the igniter depressed for about 10 seconds.
• Note: if the burner does not light after 10 seconds, turn the knob back to the "OFF" position
• and wait 1 minute before you try again.
• Repeat the above steps also for the other burners.
• Note: On some models, as well as the control knob, a separate ignition knob also needs
to be pressed.
4.5 Lighting the burners with a match extender (if provided)
If the electronic igniter does not manage to light the burners, it is also possible to light the
burners with the aid of a match.
• Put the match in the extension piece, if the barbecue is supplied with a match extender.
• Keep your face as far away as possible from the barbecue and point the extended match
through the openings in the grille toward the burner.
• Place the match close to the burner openings and turn the control knob to the "HIGFI" position.
• Note: If, after several attempts, you are still not able to light the barbecue, please
contact your sales outlet.
31