Initial Operation - Clatronic mwg 725 E Bedienungsanleitung

30449-05-MWG 725 E
formation of bubbles of steam and boiling over when the vessel is removed and
GB
slightly shaken. There is a danger of scalding! So that boiling is even, place a
glass rod or the like - but nothing metal - into the vessel.
• Never use metal tableware or tableware containing metal parts (e.g. golden
edges or wire clips) in the microwave. This will damage the machine.
• Always use the microwave oven with the turntable and the roller ring.
• Never operate the machine when the oven is empty.
• If the door frame or seal or neighbouring parts are damaged, the machine may
not be used until repaired by a service technician.
• Servicing work or any repair work may only be carried out by a service technici-
an trained by the manufacturer.
• If smoke forms in the machine, keep the door closed and switch the machine off
or disconnect it from the power supply.
• The machine should be kept under observation if meals are warmed up or cooked
in disposable containers made of plastic, paper or other combustible materials.
• The contents of glasses and bottles of baby food must be stirred or shaken
before consumption. The temperature should be checked before consumption in
order to avoid burns.
• A minimum distance at 10 centimetres should be kept clear around the machine.
• When operating the microwave oven alone never use the metal grill stand as
this will damage the machine.
Information concerning grill and combined operation
• As irradiated heat is used during grill and combined operation please use only
heat-resistant tableware.
• When operating the grill alone only metallic or aluminium tableware may be
used - but not during combined or microwave operation.
• Do not place anything on top of the housing, as this becomes hot. Always keep
the ventilation slits clear.
• Please use the grill stand to bring the food to be cooked up to the heating element.
• Remove all the accessories from the oven compartment, unpack them and place
the sliding ring in the middle. Position the glass plate on the drive axle such that
the plate fits into the hollow sections of the drive shaft and is lying level.
• Inspect the machine for visible damage, in particular in the area of the door. If
any type of damage whatsoever is found, the machine must not be used.
• In order that there is no interference from other electrical equipment during the
operation of the microwave oven, do not place your machine in the direct vicinity
of other electronic equipment.
• Remove any adhesive protective foil from the housing.
• Insert the plug into a correctly installed safety socket of 230 V, 50 Hz.
• Do not remove any fitted parts from the oven interior nor from the inside of the
door!
30
16.09.2005 12:53 Uhr

Initial Operation

Seite 30