Troubleshooting; Specifications - Boost -TOWER100 Bedienungsanleitung

• Turn ON your external audio appliance
• Use the control on your Bluetooth enabled appliance to control the volume
Trouble-Shooting
If the product is not operating properly, make a check of the items in the table
below. If the problem persists, a malfunction may be assumed. Disconnect the
power immediately and contact the store where the unit was purchased.
PROBLEMS
No function light
or no sound
Function light is
ON but no sound

Specifications

Output power
FM tuner
FM step
Impedance
Frequency response
Bluetooth frequency
Max. RF output power
Mains adaptor
Dimensions
Weight
The above specifications are for reference only. Design and specifications are
subject to change for improvement without prior notice.
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them
to a recycling centre. Ask your local authorities or your dealer about the way to proceed.
©Copyright Lotronic 2018
REASONS
Plug is not connected
well
Cable is disconnected
Failed when connect
to the Bluetooth
appliance
Volume was set at 0
degree or at mute
status
-1.55dBm (GFSK mode) / -4.6dBm (Pi/4DQPSK)
In : 100 – 240V~ 50/60Hz 0.3A; Out : 5V���� 1.5A
BOOST-TOWER100
SOLUTIONS
Insert plug into the electric outlet
Turn off the power check the input
jack to ensure the proper signal is
connected to relevant input jack
Connect the Bluetooth appliance
properly make sure it was connected
successfully
Add the volume at the proper degree
or press the MUTE key again on the
remote
100W
87.5 – 108MHz
0.1MHz
4 Ohms
60Hz – 18kHz
2402 – 2480MHz
190 x 190 x 975mm
2.9kg
6