Specifications; Specific Safety Rules; Functional Description - Makita FS2700K Betriebsanleitung

ENGLISH
1. Locator
2. Front cap
3. Switch trigger
4. Lock button

SPECIFICATIONS

Capacities
No load speed (min
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to
screwdriver safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious
personal injury.
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring or its own cord.
Fasteners contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
4
Explanation of general view
5. Lamp
6. Reversing switch lever
7. Adjusting ring
8. Pointer
Model
Self drilling screw
Machine screw
Wood screw
-1
)
Net weight
Safety class
FS2700
301 mm
SAVE THESE INSTRUCTIONS.
ENE033-1
WARNING:
MISUSE or failure to follow the safety rules stated in
ENF002-1
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
GEB017-2
Depth adjustment
For Model FS2700 only (Fig. 1)
When you wish to drive self drilling screws, etc., adjust the
depth as follows. Turn the locator to adjust the depth.
Adjust the locator to create a distance of approximately
1 mm from the tip of the front cap (which works in
conjunction with the locator) to the base of the screw
head. One full turn of the locator equals 1 mm change in
depth. (Fig. 2 & 3)
Switch action (Fig. 4)
CAUTION:
• Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
9. Hook
10. Bit
11. Sleeve
6 mm
8 mm
6.2 mm
0 - 2,500
1.8 kg
/II
FS2701
283 mm
1.7 kg