Installation; Caratteristiche Tecniche - urmet 1783/69 Bedienungsanleitung

Collegamento in derivazione da un'interfaccia di colonna Sch.1083/50 di 8 telecamere di controllo
alimentatore interfaccia
2Voice di colonna
Sch.1083/20 Sch.1083/50
dalle postazioni di
chiamata principali
§
In caso di autoinserzione, la visualizzazione delle telecamere collegate all'interfaccia Bus per TVCC
Sch.1783/69 avverrà in coda alla sequenza riportata sul libretto di sistema al paragrafo "Funzione
autoinserzione su telecamere di controllo".
IMPOSTAZIONI DI FABBRICA
Il dispositivo esce di fabbrica con le seguenti impostazioni:
ID 1
B/S BROAD.
1 AP0
2 AP0
SEL/AP
TELECAMERE
3 AP0
4 AP0
1 AP1
2 AP1
ON/OFF
TELECAMERE
3 AP1
4 AP1

CARATTERISTICHE TECNICHE

Tensione di alimentazione: ............................................................................................................... 36÷48Vcc
Consumo a riposo: ................................................................................................................................. 10 mA
Consumo massimo: ............................................................................................................................. 100 mA
Dimensioni (H x L x P): .................................................................................61 x 90 x 108 mm (6 moduli DIN)
6
interfaccia Bus
per TVCC
Sch.1783/69
ID = 1
telecamere
di controllo
IN1
interfaccia Bus
IN0
per TVCC
Sch.1783/69
ID = 0
telecamere
di controllo
DESCRIPTION
The device Ref.1783/69 allows to connect up to 4 control cameras with balun impedance adapter to 2Voice
systems.
Cameras can be assigned to the single user number 0 or 1 or assigned to all the system users.
This interface can be seen as a secondary call module. For this reason, in each riser the sum of secondary
call stations and CCTV bus interfaces can not exceed 2.
§
It is possible to use Ref.1083/69 or Ref.1038/69 devices even if in the system is installed one or more
Ref.1783/69.

INSTALLATION

The device is designed for DIN rail installation and also for wall mounting installation with screws and screw
anchors.
To connect the interface Ref.1783/69 to the system, it is mandatory to use the 2Voice system cable
Ref.1083/90 or Ref.1083/92 and to observe the regulations concerning secondary call stations that are
shown in the system booklet.
For cameras connections, use the cables described below, observing the maximum extension indications:
Cable type
CAT5
Coax RG59
(*) between the video balun Ref.1093/300A impedance adapter and the camera, a RG59 coax cable with a
maximum length of 50m can be used.
TERMINAL PINS DESCRIPTION
B1 positive input (or coax cable central conductor) camera number 1
A1 negative input (or coax cable shield) camera number 1
B2
positive input (or coax cable central conductor) camera number 2
A2 negative input (or coax cable shield) camera number 2
B3 positive input (or coax cable central conductor) camera number 3
A3 negative input (or coax cable shield) camera number 3
B4 positive input (or coax cable central conductor) camera number 4
A4
negative input (or coax cable shield) camera number 4
]
LINE IN incoming BUS line
DS1783-003A DS1783-003A
1
2
Maximum length
200m
50m
ENGLISH
Video balun
Ref.1093/300A (*)
NO
7