urmet 1783/69 Bedienungsanleitung Seite 5

]
LINE OUT outgoing BUS line
CONFIGURATION
ID: in a riser column it is possible to install 2 CCTV bus interfaces or one secondary call station and one
CCTV bus interface; the two devices must have different addresses (0 or 1).
Address 0
B/S: The images coming from cameras connected to the interface can be seen by all the users (BROAD) or
assigned to users 0 and 1 of the column (SEL/AP) by means of the dip switch "SEL/AP TELECAMERA".
Cameras are assigned
to users 0 and 1
SEL/AP CAMERAS: by setting the "B/S" dip-switch to SEL/AP, it is possible to assign all the cameras to
the user 0 (AP0) or to the user 1 (AP1). The dip-switch number corresponds to the camera number (dip
number 1 = camera connected to A1, B1 terminal pins).
Camera 1 is assigned to
the user 0
Camera 2 is assigned to
the user 0
Camera 3 is assigned to
the user 0
Camera 4 is assigned to
the user 0
§
Cameras can be associated only to users with CODE 0 and 1; the other users can see cameras images
only if the "Broadcasting" function is enabled.
8
For example, if it is requested to assign the cameras number 1 (A1,B1) and 4 (A4,B4) to the user 0 and the
other cameras to the user 1, set the dip switch in the following way:
RESET: If the CCTV Bus interface is removed from the system in order to be used in another system,
is necessary to reset it. To do this and erase all the active settings, open and close again the jumper
"RESET".
ON/OFF CAMERAS: If no camera is connected to an input or if it is needed to exclude temporarily the
selected camera from those displayed, put the respective dip-switch in OFF position. The dip-switch
number corresponds to the camera number (dip number 1 = camera connected to A1,B1 terminal pins).
Address 1
Broadcasting function:
all the users can see the
images coming from
cameras.
Camera 1 is assigned to
the user 1
For instance, if no camera is connected to A3, B3 terminal pins, set the dip-switch as follows:
Camera 2 is assigned to
the user 1
Camera 3 is assigned to
the user 1
Camera 4 is assigned to
the user 1
DS1783-003A DS1783-003A
Camera 1 is disabled
Camera 2 is disabled
Camera 3 is disabled
Camera 4 is disabled
Camera 1 is enabled
Camera 2 is enabled
Camera 3 is enabled
Camera 4 is enabled
9