Installation - urmet 1083/67 Bedienungsanleitung

ENGLISH
The apartment interface Ref. 1083/67 allows to connect telephones or a PABX to a Voice system. With this
device all Voice system typical operations can be performed using a telephone and DTMF codes.
If not Urmet products are installed in the system, it is suggested to check that telephone signals (voltage,
tones, etc.) are compatible with Italian telephone signals. Signal incompatibility could cause malfunction.
Urmet SpA refuses all responsibility for tampering or wrong connections which can damage people or
objects.

INSTALLATION

§
To evaluate the max. number of devices which can be installed in column, note that each
apartment interface must be considered as 2 apartment stations.
The product is composed by  units (power supply module and interface), which must be installed in a
service panel and connected.
TERMINAL PIN DESCRIPTION
}
+4
Terminal pins for connection to the power supply module
-4
}
au
Outgoing telephone line
bu
}
S+
Additional ringer
S-
RD Outgoing video power supply
ONV Outgoing video activation
V3 Outgoing video signal
V5 Video signal and power supply ground (RD; ONV)
]
CP Floor Call
]
Line OUT Outgoing Bus Line
]
Line IN Incoming Bus Line
CONFIGURATION AND OPERATING MODE
Default values: all the interfaces are configured in factory as follows:
USER = 17
INTERNAL CODE = 1
The interface 1083/67 can be configured to operate in two different modes:
– Mode apartment station (Dip 1 CODE = OFF). Installed in an apartment, the interface allows to manage
the door phone system from the telephones connected to the telephone output au, bu or connected to a
PABX connected to the same telephone output au, bu.
– Mode call transfer from the concierge switchboard 1083/40 (Dip 1 CODE = ON). Installed in the same
8
INT CODE
ON ON
1 2 1 2 3 4 5 6 7 8
DIP1 CODE = OFF (apartment station mode)
Line termination = ON
O N O N
= =
DS1083-01A