Special Modes; Test Printing - Oki LD670 Benutzerhandbuch

10-1. Test Printing

With paper inserted in the printer, turn off the printer power switch once, and
turn on the switch again while holding down the FEED switch on the control
panel. Then, the data shown below is printed. When "TEST PRINT" is printed,
press and hold down the FEED switch for one second or longer to start test
printing.
After printing a certain amount of data, the printer automatically cuts the
paper and ends the test printing. To terminate test printing in progress, press
the FEED switch. Then, the printer cuts the paper and terminates the test
printing.
Note: You must hold down the FEED switch until the printer starts printing.
Note: If you have passed the item that you want to select, quickly press the
FEED switch repeatedly until you return to the first item.
Test printing

10. Special Modes

Test Print
End
Sample Print
Data Analysis
Cleaning
Sensor Adjustment
Setup
Test Print
Selection Item
Special Mode
Usage
Item Selection
Please push the feed switch short.
Item Decision
Please push the feed switch long.
78