Maintenance - WOLFF TURBO-STRIPPER Originalbetriebsanleitung

Cut the strips smaller if the fl oor covering is bon-
ded very ecurely, e.g. with an epoxy adhesive.
► The blades are sharpened by the fl oor pavement.
Therefore theblade only has to be changed if it is
twisted, collateral rounded or becomes worn.
► The driving wheels are subjected to wear. They have
to be changed after approximately 16 mm (0.6 inch)
of the surface has been worn away. Otherwise the
working angle of the striking apparatus will not be cor-
rect especially critical with cork or foam backed
carpets.
4.2 Start up
► Consider the mains power. The voltage of the
power supply has to be conform with the specifi ca-
tions of the type plate.
Attention
Attention:
Check the machine before use:
► The blade has to be mounted properly.
► Make a test run of min. 1minute.
► Do not use damaged blades.
► Damaged blades can burst and injure.
4.3 Switching on/off fi g. H
► The TURBO-STRIPPER is operated by using the
handle on top of the central control panel. The machine
is switched on using switch (1). It starts immediately.
► The black lever (2) switches the drive on/off .
► By pressing the emergency stop switch (3) in the
event of danger, the entire machine can be shut
down. By turning the switch, the emergency stop is
reset.
► The machine is equipped with a zero-voltage switch.
It prevents accidental start-up after the power supply is
Reconnected
► If power is interrupted during operation, the TURBO
STRIPPER must be switched on again by pressing key
button (1)
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
4.4 Emergency running fi g.B
The Turbo-Stripper can be operated also with broken
or damaged hand clutch as follows:
► Disconnect power supply
► Insert emergency-run-plate (1) instead of the plug (2)
screw in thumb-screw (3) until the driving wheels are
blocked
► If the emergency-run-plate is mounted, the motor
drive is always switched on. The machine starts
running immediately after switching on.
5.0 Transport
To avoid injury dismount the blade while transporting the
machine. Pull out the plug from the mains. Take off the
plug of the coupling (2) fi g.B and insert the emergen-
cy-run-plate (1). Screw in thumb-screw (3) until the driving
wheels are Blocked to avoid the machine rolling away.
5.1 Carrying belt
To carry the machine, the provided carrying belts will be
fi xed at the 4 brackets (13) fi g.A.

6.0 Maintenance

Maintenance and Cleaning
► Before any work on the machine itself, pull the mains
plug.
► For safe and proper working, always keep the machine
and ventilation slots clean.
The machine must then be sent to an after-sales
Service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for WOLFF
power tools.
In all correspondence and spare parts orders, please
www.wolff -tools.de
EN
19