Restriction Of Use; Low-Voltage Protection; Maintenance - WOLFF Vario-Stripper SILENT 230 V Betriebsanleitung

3.3 Restriction of use

The Vario-Stripper SILENT is exclusively for removing bonded
floor coverings in dry environments.
It should not be used for any other purpose. Wolff cannot be
held responsible for any damage or loss caused by incorrect use.
3.4 Genuine Spare Parts
Spare parts and accessories are manufactured uniquely for the
Vario-Stripper SILENT. It must be emphasized that parts
obtained from unauthorized sources must not be used.
Wolff cannot be held responsible for the performance of or any
damage arising from the use of machines in which genuine spare
parts have not been used. This is particularly important with
replacement blades.

3.5 Low-voltage protection

The Vario-Stripper SILENT is equipped with a Low-voltage
protection switch. The power supply breaks if current fluctuation
or mains power failures occur, thus preventing serious perilous
accidents.
Due to the restart protection, the machine will not restart after a
power failure, even if the operation switch has not been
switched off. For using the protective cut-out switch see also
item 5.0 Application

4.0 Maintenance

The Vario-Stripper SILENT is virtually maintenance-free.
Changing the blade
Disconnect the power supply before changing the blade. Use
work gloves for your own safety.
r put on the blade protection (enclosed in the tools set)
r clean and loosen the screws of the blade mounting.
r Set the wrench at a position opposite the blade to avoid injury.
r replace the blade.
Make sure that the blade fits in exactly into the support. On normal
and hard subfloors the bevel of the blade should show upwards
(1), on soft subfloors (e.g. chipboards) the bevel should show
downwards (2). (Pic. 2)
Changing the driving wheels
Remove the splint-pins and pull the wheels from the axle. Do not
loose the springs (Pos. 53) under any circumstances! (Pic. 3)
03/2006 Vario-Stripper SILENT , Artikel-Nr. 038764Fu
Wolff cannot be held responsible for any damage or
loss caused by incorrect use Correct use also includes
r to take care of all directions from the operating
manual and
r the execution of maintenance and service.
1
52
53
(pic. 1)
Blade holder
Abweiser Blech
Hexagon bolt
Sechskantmutter
Replacement
Ersatzmesser
blade
Screw
Flachrundschraube
machine truss mit Vierkantansatz
Blechschwinger
Striker Foot
Casting
angle
Winkeladapter 15°
adapter
Sechskantmutter
Hexagon nut
Flachrundschraube
Screw
mit Vierkantansatz
machine truss
(pic. 2)
2
32
30
(pic. 3)
11