Vector Active Series Front Panel; Volume Control - HH Electronics VECTOR VRM-110A Bedienungsanleitung

VECTOR ACTIVE SERIES FRONT PANEL

VECTOR ACTIVE SERIES FRONT PANEL
1. COMBI INPUT: A line level balanced input compatible with balanced and unbalanced
XLR and jack signal leads.
Note; as this is a balanced input, a stereo signal cannot be connected to this
socket. It is not compatible with microphone level inputs and is not suitable for direct connection to a
microphone. Use only good quality shielded signal cables.
2. LINK OUTPUT: A balanced XLR output, parallel to the input. Use this to pass the
signal along to another active cabinet.
3. VOLUME CONTROL: Adjusts the overall level available from the monitor.
4. POWER LED: Illuminates when the unit is connected to the mains supply and switched
on.
5. PEAK LED: Illuminates just before the amplifier begins to clip and distort. Adjust the
level control and signal level from your source so this illuminates only briefly on peaks in the
music. Using the monitor with this on all or much of the time will result in poor sound
quality and damage to speakers and electronics.
6. GRAPHIC EQUALISER: A five band graphic equaliser is provided to remove
feedback and fine tune your sound. Feedback may be reduced by moving the slider at the
closest frequency downwards to cut power in that band. For best results use the EQ only
for small adjustments, not to try and redefine the sound completely.