Care And Cleaning; Service And Customer Care - Kenwood SJ330 serie Handbuch

boil-dry protection
G
For safety your kettle is fitted with a
re-setable thermal fuse. If you switch
on with too little water, your kettle
will cut out automatically. Switch off
and let it cool down before re-filling.
When it has cooled down, the switch
will reset itself.

care and cleaning

Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
G
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
G
Wipe with bicarbonate of soda on a
damp cloth. Rinse thoroughly.
G
Even though your kettle comes with
a scale filter, you still need to clean
the inside (and the filter) regularly.
the scale filter
1 Open the lid.
2 Remove the scale filter by
the tab and then lifting the filter out.
3 either rinse under the tap or use a
soft brush
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 To re-fit the filter, hold the tab
Then slide the filter down into the
bracket until secure
descaling
G
When limescale builds up on the
heating element, buy a suitable
descaler and descale your kettle.
Limescale makes your kettle take
longer to boil and can make the
element burn out. After descaling,
boil with fresh water several times
and discard. Clean any descaler off
the kettle - it can damage the parts.
holding
.
.
3
G
Some regions of the country have
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle.
This is normal but can be removed
with regular cleaning.
G
Alternatively, to reduce limescale
build up, use filtered water to fill your
kettle.
G
A range of Kenwood jug water filters
are available.
service and customer
care
G
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
G
using your kettle
G
servicing or repairs
Contact the shop where you bought
your kettle.