Herunterladen Inhalt Inhalt Diese Seite drucken

Mode Button - AEG AR 4027 Bedienungsanleitung

Autoradio mit usb & card reader usb/cr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
f
Threaded bolt
g Slide-in housing
h Extraction tool (spanner for dismantling)
Connection
Connect the device as shown in the diagram.
CAUTION:
• Please use loudspeakers with an impedance of 4 ohm.
• The loudspeaker cables must be unearthed.
Connection of an external amplifier
For the connection of an external amplifier use the audio
cinch
output LINE OUT at the rear side of the device. Refer to
the instruction manual concerning the external amplifier.
Operating Instructions
1. Do not switch on the device if the car interior is extremely
hot, for example after an extended parking in direct sun-
light. Wait until the interior is cooled down after a short
drive.
2. Possible malfunctions during operation can be resolved
by pushing the RESET button. Push the RESET button
with a wire or similar (10) to reset the electronics (RESET).
3. The time displayed in standby mode is set automatically
as soon as you listen to a radio station. Manual setting is
not possible.
Operation
In the following, the functions of the individual device buttons
are described according to the illustration
the Components".

1 MODE Button

Press this button to select the different modes. (Radio,
USB, CARD and AUX)
NOTE:
The USB and CARD mode can only be selected if you
have connected a corresponding medium.
2 Station presets (1-6)
a) In radio mode:
• Hold down the desired station preset button to
save a radio station.
• To choose a radio station, shortly press the
respective station button.
• To select a program type.
"BAND/PTY button"
b) In USB/CARD mode:
Direct selection of a music file.
"AS/PS button"
3 Volume control / On-/Off / SEL Button (Select)
a) Press the control to switch on the device. Hold down
the control to switch off the device. The time appears
on the display.
b) During normal playback mode, the control is used to
control the volume.
Together with the previously pressed control (SEL
button), changes can be made in the menu, e. g. the
sound mode.
c) Press the SEL button shortly to enter the selection
menu. Repeated pressing of the SEL button selects
individual menu entries. You can change the settings
of the individual menu entries by turning the volume
control.
English
39
"Overview of
Page 41
Page 41

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis