UNLOCKING THE PANEL HEATER'S HANGING FRAME
We recommend that you place the panel heater face down on the floor, taking care to protect its
front surface from scratches.
Take a flat-bladed screwdriver and lift the
1
slider, taking care not to bend it.
Swivel the hanging frame downwards on
3
the lower brackets S1.
FIXING THE HANGING FRAME TO THE WALL
Place the
1
hanging
frame on
the floor
against the
wall. Locate
drilling
points A.
Drilling points A show the position for the
lower fastenings.
Drill the 4 holes and insert the wall plugs.
3
Use suitable wall plugs when fitting on a
specific support (e.g. plasterboard wall).
S1
Drilling
points A
31
While keeping the sli-
2
der raised, push the
hanging frame towards
the bottom of the
heater to release the
upper brackets S2. We
recommend that you
wear protective gloves.
Remove the hanging frame.
4
Refit the hanging
2
frame, lining up
with drilling
points A to find
drilling points B
(you can also use a
level).
Drilling points B show the position for the
upper fastenings.
Position the hanging frame and screw it
4
down.
GB
S2
Drilling
points B
Drilling
points A