Selecting A Fan Setting; Switching Off The Appliance; Switching On The Lighting; Switching Off The Lighting - Bosch DBB66AF50 Gebrauchsanleitung

en Cleaning and servicing

Selecting a fan setting

Set the control knob to any fan set-
▶
ting.

Switching off the appliance

Set the control knob to ⁠ .
▶

Switching on the lighting

Set the control knob to
1.
To use the lighting at the same time
2.
as a fan setting, set the control knob
to , or

Switching off the lighting

Set the control knob to ⁠ .
▶

Cleaning and servicing

To keep your appliance looking its best
and working efficiently for a long time,
it is important to clean and maintain it
carefully.

Cleaning products

You can obtain suitable cleaning
products from after-sales service or the
online shop.
WARNING
Risk of electric shock!
Penetrating moisture may cause elec-
tric shock.
Do not use steam- or high-pressure
▶
cleaners to clean the appliance.
ATTENTION!
Unsuitable cleaning products may
damage the surfaces of the appliance.
Do not use harsh or abrasive deter-
▶
gents.
Do not use cleaning products with a
▶
high alcohol content.
28
.
⁠ .
Do not use hard scouring pads or
▶
cleaning sponges.
Do not use any special cleaners for
▶
cleaning the appliance while it is hot.
Do not use limescale remover on the
▶
door handle or control panel, as it
may leave permanent staining.
Only use glass cleaners, glass
▶
scrapers or stainless steel care
products if recommended in the
cleaning instructions for the relevant
part.
Wash sponge cloths thoroughly be-
▶
fore use.
Cleaning the stainless steel
surfaces
Observe the information regarding
1.
the cleaning agents.
→ "Cleaning products", Page 28
Clean using a sponge cloth and hot
2.
soapy water in the direction of the
finish.
Dry with a soft cloth.
3.
Apply a thin layer of the stainless
4.
steel cleaning product with a soft
cloth.
Tip: You can obtain stainless steel
cleaning products from after-sales ser-
vice or the online shop.

Cleaning painted surfaces

Observe the information regarding
1.
the cleaning agents.
→ "Cleaning products", Page 28
Clean using a sponge cloth and hot
2.
soapy water in the direction of the
finish.
Dry with a soft cloth.
3.

Cleaning aluminium

Observe the information regarding
1.
the cleaning agents.
→ "Cleaning products", Page 28