Operating The Appliance; Setting The Fan; Fan Run-On Time; Intensive Setting - Bosch DWK09G6.0 Gebrauchsanleitung

Operating the appliance

These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Explanation
Fan off
%
1 Fan speed 1
2 Fan speed 2

Fan run-on time

r
3 Fan speed 3

Intensive setting

°
Light On/Off
B

Setting the fan

Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
Press button 1, 2 or 3.
The button and the set fan speed light up to confirm
%
activation.
Switching off
%
Press the button.

Cleaning and maintenance

:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Penetrating moisture may cause an electric shock. Do not use
any high-pressure cleaners or steam cleaners.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
12
Fan run-on time
Fan run-on is possible at any fan speed.
First, press the button corresponding to the desired fan
1.
speed: 1, 2 or 3 .
To activate fan run-on, press and hold button 2
2.
2 seconds.
The button and the set fan speed flash to confirm
%
activation.
Press the % button to end the fan run-on early.
3.
Notes
The run-on time is 30 minutes for all fan speeds. Once this
■
time has elapsed, the ventilation and lights switch off
automatically.
The fan speed can be altered during the run-on time.
■
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
To activate the intensive setting, press and hold button 3
1.
2 seconds.
The % button lights up and button 3
activation.
To end the intensive setting early, press the
2.
Note: The intensive setting runs for 10 minutes. Once this time
has elapsed, the appliance returns to the fan speed previously
set.

Lighting

The lighting can be switched on and off independently of the
ventilation.
Press the button.
@
Setting the brightness
When switching on the lights, press and hold the
2 seconds. The brightness is reduced.
Note: When switching on the lights again, the brightness is set
to maximum once again.
Cleaning agents
Observe the information in the table to ensure that the different
surfaces are not damaged by using the wrong type of cleaning
agent. Do not use
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
r for
for
°
° flashes to confirm
button.
%
button for
@