Use - Tunturi T40 Benutzerhandbuch

‼ NOTE
• Do not use the hand pulse sensors in combination with a heart
rate chest belt.
• If you set a heart rate limit for your workout, an alarm will sound
when it is exceeded.
Heart rate measurement
(heart rate chest belt)
‼ NOTE
• A chest strap does not come standard with this trainer. When
you like to use a wireless chest strap you need to purchase this
as an accessory.
The most accurate heart rate measurement is achieved with a heart
rate chest belt. The heart rate is measured by a heart rate receiver
in combination with a heart rate transmitter belt. Accurate heart
measurement requires that the electrodes on the transmitter belt are
slight moist and constantly touching the skin.
If the electrodes are too dry or too moist, the heart rate measurement
will become less accurate.
⚠ WARNING
• If you have a pacemaker, consult a physician before using a
heartrate chest belt.
⚠ CAUTION
• If there are several heart rate measurement devices next to each
other, make sure that the distance between them is at least 1.5
metres.
• If there is only one heart rate receiver and several heart rate
transmitters, make sure that only one person with a transmitter
is within transmission range.
‼ NOTE
• Do not use a heart rate chest belt in combination with the
handpulse sensors.
• Always wear the heart rate chest belt under your clothes directly
in contact with your skin. Do not wear the heart rate chest belt
above your clothes. If you wear the heart rate chest belt above
your clothes, there will be no signal.
• If you set a heart rate limit for your workout, an alarm will sound
when it is exceeded.
• The transmitter transmits the heart rate to the console up to a
distance of 1 metre. If the electrodes are not moist, the heart
rate will not appear on the display.
• Some fibers in clothes (e.g. polyester, polyamide) create static
electricity which can prevent accurate heart rate measurement.
• Mobile phones, televisions and other electrical appliances
create an electromagnetic field which can prevent accurate
heart rate measurement.
Maximum heart rate
(during training)
The maximum heart rate is the highest heart rate a person can safely
achieve through exercise stress. The following formula is used to
calculate the average maximum heart rate: 220 - AGE. The maximum
heart rate varies from person to person.
⚠ WARNING
• Make sure that you do not exceed your maximum heart rate
during your workout. If you belong to a risk group, consult a
physician.
Beginner
50-60% of maximum heart rate
Suitable for beginners, weight-watchers, convalescents and persons
who have not exercised for a long time. Exercise at least three times a
week, 30 minutes at a time.
Advanced
60-70% of maximum heart rate
Suitable for persons who want to improve and maintain fitness.
Exercise at least three times a week, 30 minutes at a time.
Expert
70-80% of maximum heart rate
Suitable for the fittest of persons who are used to long-endurance
workouts.

Use

Master power switch (fig. E-2A)
The equipment is equipped with a master power switch to shut down
the equipment completely.
To start the equipment:
- Insert the mains plug into the equipment.
- Insert the mains plug into the wall socket.
- Set the master power switch to the on position.
To stop the equipment:
- Set the mains power switch to the off position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
Safety key (Fig F-4)
The equipment is equipped with a safety key that must be properly
inserted into the console to start the equipment. If you remove the
safety key from the console, the equipment will stop immediately.
- Insert the safety key into the slot in the console.
- Make sure that the clip of the safety key is properly attached to
your clothing.
Make sure that the clip is not removed from your clothing before
the safety key is removed from the console.
‼ NOTE
• Console will show E7 code when safety key is not in (correct)
position during start up.
Circuit breaker (Fig. E-2B)
The equipment is equipped with a circuit breaker that interrupts the
circuit when the electricity load is above the maximum capacity. When
this occurs, the circuit breaker must be pressed.
⚠ WARNING
• Before pressing the circuit breaker, remove the mains plug from
the equipment.
If the equipment shuts down, proceed as follows to restart the
equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the equipment.
- Insert the mains plug into the equipment.
‼ NOTE
• Some circuit breakers used in homes are not rated for high
inrush currents that can occur when a treadmill is first turned
on or even during normal use. If your treadmill is tripping the
circuit breaker (even though it is the proper current rating and
the treadmill is the only appliance on the circuit) but the circuit
breaker on the treadmill itself does not trip, you will need
to replace the breaker with a high inrush type. This is not a
warranty defect. This is a condition we as a manufacture have no
ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1) and folded for
transport and storage (fig. F2).
Refer to the illustrations for the correct way of unfolding and folding
the equipment.
⚠ CAUTION
• Before folding the equipment, make sure that the incline is 0. If
the incline is not 0, folding will damage the mechanism.
1 7
English