Bosch I2 Serie Gebrauchsanleitung Seite 25

The iron begins
to smoke when
switched on.
The iron does not
produce any
steam.
Dirt comes out
through the
soleplate.
The
"Calc'nClean"
does not turn off.
The appliance
makes a pumping
sound.
The iron drips.
The iron
produces little
steam.
If the above tips do not solve the problem, get in touch
with our customer service.
* Model dependent
components on the
appliance have been lightly
greased at the factory and
may produce a small
amount of smoke when
initially heated.
completely.
2. The "Calc'nClean" indicator
descaling process has not
been completed.
1. There is a build up of
limescale or minerals in the
iron.
2. Chemical products or
additives have been used.
1. The iron descaling process
has been stopped before
being completed.
1. Water is being pumped into
the iron.
2. The water tank is empty.
1. Ironing programme selection
mode and the "high steam"
permanently.
1. The iron has been switched
on recently.
1. This is completely normal
and will stop after a short
while.
1. Press and hold the steam
until steam comes out.
2. Perform a cleaning cycle
1. Carry out a cleaning cycle
2. Never add products to the
Clean the soleplate with a
damp cloth.
1. Restart and complete the
iron descaling process.
1. This is normal.
2. Fill the water tank.
1. When you iron in "i-Temp"
until the "medium steam"
1. It is normal, the iron
produces steam gradually
until it is stabilized.
25
B O S C H