Maintenance/Disposal; Lubricating The Cutting Mechanism; Automatic Energy Saving; Disposal Of The Machine - Garner FLASHPRO Betriebsanleitung

US
• Has the motor been overloaded?
➢ See "Motor protection", Section 4.4.
NOTE!
In many cases, restarting the machine helps:
1. Switch off the machine once.
2. Turn the machine on again.
If none of these test points apply, please notify your Garner
service partner.

5. Maintenance/Disposal

NOTE!
Regular maintenance by your intimus service partner is
recommended.
5.1 Lubricating the cutting
mechanism
Cross-cut cutting mechanisms must be lubricated regularly after
a certain period of operation. As a reminder, the
(Fig. 1/7) lights up after 20 minutes of operation.
Lubricate the cutting mechanism:
1. Open the safety glass (Fig. 3/1).
➢ The
pilot lamp (Fig. 1/6) lights up.
➢ The
pilot lamp (Fig. 1/7) flashes.
➢ The
reverse button's pilot lamp (Fig. 1/6) flashes.
2. With the included oil bottle, dispense a thin streak of oil from
left to right onto the cutting mechanism.
3. Press the reverse button (Fig. 1/5).
➢ The
pilot lamp goes out.
4. Close the safety glass again.
➢ The
pilot lamp goes out.
➢ The
pilot lamp continues to flash.
The motor starts automatically to distribute the oil on the cutting
rollers. The cutting mechanism moves forward and backward
a few times during the lubrication process. The or
indicators flash depending on the direction of rotation.
The motor then switches off. The
out. The machine is now ready for operation again. To reorder
oil bottles, see "Accessories", Section 7.

5.2 Automatic energy saving

If the machine is not in use, it automatically turns of f after about
10 minutes The LED display on the function button (Fig. 1/1)
goes out to indicate "ready for operation." To reset, briefly press
the function button.
7 of 26
pilot lamp
LED
pilot lamp (Fig. 1/7) goes

5.3 Disposal of the machine

Always dispose of the machine at the end of its
service life in an environmentally responsible way.
Do not toss any part of the machine or its packaging
into the garbage.

6. Technical Data

SPECIFICATIONS
Particle Size 0.2 x 0.6 (in.)
4 x 15 (mm) Cross-Cut
Cutting capacity/hour* 150 Smartphones
500 USB sticks
1500 CDs
1000 Floppy
Working width 165 mm
Input voltage 230 V/50 Hz, 240 V/50 Hz, 120 V/60 Hz:
Fusing (idle) 230 V/50 Hz = 16 A
240 V/50 Hz = 13 A
120 V/60 Hz = 20 A
Noise level approx. 65 dB (A)
Output 1.9 kW
Dimensions (WxDxH) 580 x 610 x 980 mm
Weight approx. 116 kg
* Particle size/cutting capacity may vary depending on shredding material
and ambient conditions.

7. Accessories

Designation
Plastic bag, 440 x 330 x 950 x 0,05 mm
Oil bottle, 110 ml
NOTE!
When reordering special accessories and to purchase
spare parts, please contact your Garner service
partner.
Item #
3800-121
1600-076