Feed Slot" Operator Unit; Turning The Machine On; Initialization Process; Starting The Shredding Process - Garner FLASHPRO Betriebsanleitung

US
7. "Lubricate cutting mechanism" pilot lamp (Fig. 1/7)
Lights up if the machine needs to be lubricated.
NOTE!
If the safety glass for the oiling process is open, the
lamp starts flashing.
8. "Material jam" pilot lamp (Fig. 1/8)
Lights up if the cutting mechanism is jammed.
9. "Cutting mechanism ready" / "Cutting mechanism
not ready" curved pilot lamps (Fig. 1/9)
Lights up green if the cutting mechanism can be fed.
Lights up red if the cutting mechanism cannot be fed.

3.2 "Feed slot" operator unit

2
1. Safety glass
2. Feed flap
Fig. 2 Garner FLASHPRO feed slot
1. Safety glass (Fig. 2/1)
The machine only runs if the safety glass is closed.
2. Feed flap (Fig. 2/2)
Feed the material through the device's feed flap. This starts
the cutting mechanism.

3.3 Turning the machine on

Briefly press the function button (Fig. 1/1).
➢ The
LED display on the function button lights up to
indicate "ready for operation."
➢ You can now feed the machine.
3.4 Initializing process
NOTE!
During the initialization process, please do not feed
any material into the shredder!
Start the initialization process (when the machine
is off):
1. Briefly press the function button (Fig. 1/1).
➢ The machine turns on.
2. Briefly press the forward button (Fig. 1/2).
➢ The initialization process starts. The cutting mechanism
switches five times between forward and backward
operation.
➢ The cutting mechanism stands still. You can now feed the
machine.

3.5 Starting the shredding process

DANGER!
Risk of injury! Damage to the machine!
☞ Remove batteries from the device before
CAUTION!
Material jam! Damage to the machine!
▲ Feed the data carriers into the machine
individually, one ater another! This lets the Garner
1
FLASHPRO reach its best performance.
▲ If too much material has reached the cutting
mechanism, see "Material jam". Section 4.1
Feeding through the feed flap (Fig. 3/2)
Slip small data carriers, like USB sticks, mobile phones
or SSD disks, through the feed flap into the cutting
mechanism.
➢ The shredding process starts automatically.
➢ After destroying the data carrier, the machine shuts off
automatically.
1. Safety glass
2. Feed flap
Fig. 3 Feeding through the feed flap
Feeding through the safety glass (Fig. 3/1)
1. For larger data carriers, e.g. mini tablets, push the safety
glass back and feed the data carrier into the cutting
mechanism.
2. Close the safety glass again.
shredding it!
1
2
4 of 26