Switching The Machine Off; Emptying The Catch Basket - Garner FLASHPRO Betriebsanleitung

US
3. Briefly press the forward button (Fig. 1/2).
➢ The shredding process starts.
➢ After destroying the data carrier, the machine shuts off
automatically.
NOTE!
While shredding, repeated reversing (switching
between forwards and backward operation is normal.
this is part of the shredding prcess and does not
indicate a failure.
Smart shredding function
The Garner FLASHPRO has a smart shredding function.
When a device is fed into the machine, it is possible the
cutting rollers do not immediately grip the device.
In this case the machine reverses automatically. This brings
the material to shred into a new position.
This sequence can happen up to five times in succession.
As soon as the cutting rollers grip the device, they start
shredding it.
If after five sequences the cutting rollers cannot grip the
device, the cutting mechanism stops (see "Failure",
section 4).
"Cutting mechanism ready" / "Cutting mechanism
not ready" indicator
The curved pilot lamps (Fig. 1/9) show whether material can
be fed into the machine or not:
• Green light: machine is ready!
The cutting mechanism can be fed.
• Red light: machine is busy!
The cutting mechanism is already working and cannot
be fed.
Stopping the shredding process manually
The shredding process can be manually stopped at any time
by briefly pressing the function button (Fig. 1/1) or the reverse
button (Fig. 1/5).
NOTE!
After 10 min without use the machine shuts off
automatically.

3.6 Switching the machine off

Press and hold the function button (Fig. 1/1) for
about 3 seconds.
➢ The machine turns off.
5 of 26

3.7 Emptying the catch basket

NOTE!
Please consult the appropriate recycling services
in your area to learn how to properly dispose of the
shredded material!
1
1. Door
2. Catch basket
Fig. 4 Catch basket
If the catch basket is full, the motor switches off. The
lamp (Fig. 1/4) lights up. The curved pilot lamps (Fig. 1/9) flash.
Proceed as follows to empty the catch basket (Fig. 4/2):
1. Open the door (Fig. 4/1).
➢ The
pilot lamp (Fig. 1/6) lights up.
2. Remove the catch basket with the full bag.
➢ The
pilot lamp (Fig. 1/4) goes out.
3. Pull the bag out to its full length, tie it up and seal it with
adhesive tape or cable ties.
4. Remove the bag and dispose of it with the contents.
5. Insert an empty bag in the basket.
6. Insert the basket back into the machine.
7. Close the door.
➢ The
pilot lamp goes out.
➢ The machine is ready for operation.
NOTE!
The machine only runs if the door and the safety glass
are closed!
2
pilot