Velleman VLE612 Bedienungsanleitung Seite 4

 Due to constant product improvements, the actual product
appearance might differ from the shown images.
 Product images are for illustrative purposes only.
 Do not switch the device on immediately after it has been exposed
to changes in temperature. Protect the device against damage by
leaving it switched off until it has reached room temperature.
 Keep this manual for future reference.
4. Features
 charger for rechargeable lead acid batteries
 automatically switches to trickle charging to maintain full capacity
of the battery
 LED indication
 protected against polarity reversal
 auto 6 V / 12 VDC voltage detection technology
5. Operation
This charger is specifically designed for charging lead batteries.
1. Connect the charger to the lead battery and check the polarity.
2. Plug the charger into a standard household AC outlet. The
charging starts and the LED indicator will light up.
3. When the battery is charged, the charger will automatically
switch to the trickle charge mode, illustrated by the flashing
charging indicator.
4. Disconnect the unit when the charging is finished and disconnect
the battery. Never disconnect the battery connector by pulling
the wires!
5. Once the charger is disconnected from the AC outlet or the
battery is disconnected from the charger, the latter will be reset
automatically. The user can start charging another battery
immediately by resuming the above-mentioned steps.
6. LED Status
LED on
LED flashing
LED off
V. 02 – 26/03/2015
VLE612
rapid charge
battery fully charged
battery not connected or wrong polarity
4 ©Velleman nv