Using A Chest Belt - Fuel LB 100 Benutzerhandbuch

Incline self-adjustment
In standby mode, press STOP- and "Speed5" button to initiate the self-adjustment process. The
device automatically returns to standby mode after the process is finished.
Power-saving mode
If there is no button pressed within 4 minutes in standby mode, the system will enter the
power-saving mode. The display will be shutdown. Press any button to wake the system up
again.
Error Codes
Er1: Signal transmission failure to display
Er3: Overvoltage
Er4: IGBT short circuit (overcurrent)
Er5: Overload
Er6: Motor not connected
Er7: Controller connection failure
Er8: Preventing reversing switch action
Er13: Overcurrent
Er14: Overload; short-circuit
Using a chest-belt
You may use a (compatible) chest belt with this device or you can use the heart rate sensors on the
handgrips to measure your heart frequency. If you use a chest belt, pay attention to the instructions of the
chest belt – however, generally a connection between a chest belt and your device may be established
like this:
1. Attach the transmitter to the elastic strap using the lock button.
2. Adjust the strap as tightly as possible as long as the strap is not too tight to
remain comfortable.
3. Position the transmitter with the logo centered in the middle of your torso
facing away from your chest (some people must position the transmitter
slightly left of center). Attach the final end of the elastic strap by inserting the
round end and, using the locking parts, secure the transmitter and strap
around your chest.
4. Position the transmitter directly below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heart beat electrical signals.
6. However, plain water can also be used to pre-wet the electrodes (2 ribbed oval areas on the reverse
side of the belt and both sides of the transmitter). It's also recommended that you wear the
transmitter strap a few minutes before your work out. Some users, because of body chemistry, have
a more difficult time in achieving a strong, steady signal at the beginning. After "warming up", this
problem lessens.
Your workout must be within range - distance between transmitter/receiver – to achieve a strong
7.
steady signal. The length of range may vary somewhat but generally stay close enough to the
console to maintain good, strong, reliable readings. Wearing the transmitter directly on bare skin
assures you of proper operation. If you wish, you may wear the transmitter over a shirt. To do so, wet
the areas of the shirt that the electrodes will rest upon.
Note: The transmitter is automatically activated when it detects activity from the user's heart.
Additionally, it automatically deactivates when it does not receive any activity. Although the transmitter
is water resistant, moisture can have the effect of creating false signals, so you should take
precautions to completely dry the transmitter after use to prolong battery life (estimated transmitter
battery life is 2500 hours). The replacement battery needs to be of the type CR2032.
33