Technical Data - AEG ABB68811LS Benutzerinformation

Problem
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Door does not open easily.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
8.2 Closing the door
1. Clean the door gaskets.

9. TECHNICAL DATA

9.1 Technical data
Dimensions of the appliance
Possible cause
The "FROSTMATIC func-
tion" is switched on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
You attempted to re-open
the door immediately after
closing.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Height
Width
ENGLISH
Solution
Switch off "FROSTMATIC
function" manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "FROST-
MATIC function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
Wait a few seconds between
closing and re-opening of
the door.
873 mm
540 mm
27