AEG ABB68811LS Benutzerinformation Seite 26

26 www.aeg.com
Problem
The appliance is noisy.
Audible or visual alarm is on. The cabinet has been re-
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature.
Possible cause
There is no voltage in the
mains socket.
The appliance is not suppor-
ted properly.
cently switched on.
The temperature in the ap-
pliance is too high.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
Solution
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified elec-
trician.
Check if the appliance
stands stable.
Refer to "Door Open
Alarm"or "High Tempera-
ture Alarm".
Refer to "Door Open
Alarm"or "High Tempera-
ture Alarm".
Refer to "Operation" chap-
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.